Search Results

Refine

Result Type

1 - 8 of 8 Products for '25 Pin Adapter' Page 1 of 1 |
  • 1
Related Categories: Talisker Ultra | Epm2000 | Powermax Pm10 | Mbr | Diamond K250

25 Pin Adapter

COHERENT LMC 2016-2017 Catalog .pdf

COHERENT LMC 2016-2017 Catalog .pdf

95
· Toll Free: (800) 343-4912 · Tel: (408) 764-4042 · Fax: (503) 454-5727
The J-Power Pro is a compact sensor adapter
that powers the active sensor circuit in DB-25
EnergyMax and PowerMax-Pro sensors and
passes the raw output voltage of the sensor
directly to the BNC…

FMII-TOP QuickStartGuideRevAD.fm

FMII-TOP QuickStartGuideRevAD.fm

Carefully review the following safety information to avoid
personal injury and to prevent damage to this meter or any
sensor connected to it.
Tuning a Laser With a Thermopile or
Optical Sensor
Follow all laser safety procedures. The
laser must be blocked or switched OFF…

FMII-P QuickStartGuideRevAD.fm

FMII-P QuickStartGuideRevAD.fm

…a pyroelectric sensor to the
FieldMaxII-P 25-pin connector. Note: If your sensor
has a BNC plug, you will need to attach
a 25-pin adapter.
n
o
Press either the Up
or Down arrow to
manually select the
range.
Adjust the trigger threshold from 2 to 20%…

book.book

book.book

ix
6-11. Dimensions - Adapter Plate for Heat Sink Mount .................................................................6-5
6-10. Adapter Plate for Heat Sink Mount.........................................................................................6-5
6-13. Dimensions -…

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

…VAC external adapter
Power Supply Current (A) 3 at ambient temperature
4 maximum
Built-In Protection Entire product: ESD, over-voltage, reverse polarity of power supply
Laser diode: overheating, over-current
Laser Diode Operating Temperature (°C) 25 ±0.5 (adjustable…

LabMax PC Software Installation and Quick Start Guide

LabMax PC Software Installation and Quick Start Guide

…or optical
sensor to the 25-pin connector
and turn the meter ON.
Note: Contact Coherent if the
sensor has a BNC plug and did
not ship with a 25-pin adapter
(refer to the "Calibration and
Warranty" section of the User
manual for contact information).

FieldMaxII-P User Manual

FieldMaxII-P User Manual


Connect a pyroelectric sensor to the
25-pin connector. Note: If your sensor
has a BNC plug, you will need to attach
a 25-pin adapter.

Press either the Up or Down
arrow to manually select the range.
Take the measurement and observe the result on the display.

FieldMaxII-TOP User Manual

FieldMaxII-TOP User Manual

Connect a pyroelectric sensor to the
25-pin connector. Note: If your sensor
has a BNC plug, you will need to attach
a 25-pin adapter.

Press either the Up or Down
arrow to manually select the range.
Note: Auto Range is not
available for this type of sensor.