Search Results

Refine
1 - 8 of 8 Products for 'Cdrh Fault' Page 1 of 1 |
  • 1

Cdrh Fault

Book.book

Book.book

…Emission Status screen indicates the current state of laser
output and system status. The central indicator also shows Standby,
CDRH Delay, and System Faults. The ON and OFF buttons are used
to toggle laser emission.
Laser Mode Status The Laser Mode Status indicators display the…

Coherent BioRay Operator's Manual

Coherent BioRay Operator's Manual

…Bit Mask Bit Label Definition
0 1 Laser Fault Any laser faults
1 2 Laser Emission Laser emission status
2 4 Laser Ready Laser ready status
3 8 Laser Standby Laser standby status
4 10 CDRH Delay Laser CDRH delay status
5 20 Laser Hardware Fault Any hardware faults

Lasers-for-Life-Sciences-Product-Guide FORMFIRST.pdf

Lasers-for-Life-Sciences-Product-Guide FORMFIRST.pdf

…Weight (g) <70
Length (mm) 95
Diameter (mm) 19.05
Material Black annodized AL 6061 T1
Commands Description
CDRH Enables/Disables CDRH Delay
BAUD Set Baud Rate
HAND Enables/Disables SCPI Handshaking
HOUR Reports System Lasing Hours
MOD Reports Laser…

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

…details of the laser from
serial number to operating hours. A separate Fault
Screen also shows any faults from an interlock fault to
over-temperature.
The Control Box
To comply with the CDRH safety requirements for a
Class IIIb laser, the CUBE includes both the shutter…

Coherent StingRay Laser Safety and Installation Quick Start Guide

Coherent StingRay Laser Safety and Installation Quick Start Guide

LED Indicator and Analog Fault Output Status
For information about fault conditions, refer to the
Coherent StingRay Operator's Manual (1223124).
Multi-State LED
5 Hz flashing
Steady on
Fault
Condition
All other
conditions
Red LED Green LED
Laser…

book.book

book.book

…Laser Fault Laser faults (see Table 5-5)
1 00000002 Laser Emission Laser emission status
2 00000004 Laser Ready Laser emission readiness status
3 00000008 Laser Standby Laser standby mode status
4 00000010 CDRH Delay Laser CDRH delay status
5 00000020 Laser Hardware Fault

PL-501 Book.book

PL-501 Book.book

…described in more detail in the following sub-sections.
NOTICE!
Operating the laser alone is not CDRH compliant. The user takes all
responsibility for safety and compliance to CDRH 21 CFR 1040 and
IEC 60825-1.
On/Off Switch The ON/OFF switch on the back panel is used to turn…

Revolution High-Power Q-Switched Laser System Preinstallation Manual

Revolution High-Power Q-Switched Laser System Preinstallation Manual

…instructions for operating and maintaining the
Revolution safely.
CDRH
Requirements for
Operating via
RS-232 Software
Commands
The Revolution and power supply comply with all applicable CDRH
safety standards when operated via commands sent to the RS-232