Search Results

1 - 12 of 49 Products for 'Cooling Chiller' Page 1 of 5 |

Cooling Chiller

Verdi preinstall.book

Verdi preinstall.book

…switch shall be clearly marked as the disconnecting device for the laser, and shall be
within easy reach of the operator.
LASER HEAD AIR COOLED
POWER SUPPLY
UMBILICAL
FACILITY
POWER
WATER LINES (if using Water Cooling)
CHILLER FACILITY
POWER

00 Laser Cooling.book

00 Laser Cooling.book

…systems, designed to match the operating requirements of
ion lasers. Details are given in Appendix A: Coherent Cooling
Options.
Closed-Loop
Chiller
Chillers have many of the same advantages of heat exchangers
insofar as a fixed volume of water is recirculated through…

Diamond J-5 Series OEM Lasers Preinstallation Manual, Rev. AC

…be cooled by a separate chiller.
Coolant Temperature At the laser head, the inlet temperature of the cooling fluid should
always be above the dew point to prevent condensation from
developing inside the laser head or RF power module.
Figure 3-1. Coolant Flow Diagram
Chiller

Revolution High-Power Q-Switched Laser System Preinstallation Manual

Revolution High-Power Q-Switched Laser System Preinstallation Manual

Chiller, Turbine Pump, Air-Cooled Condenser, Single Phase, 1500W
Cooling Capacity @ 240VAC/50Hz
1234950
Chiller, Turbine Pump, Air-Cooled Condenser, Single Phase, 1800W
Cooling Capacity @ 208/230VAC/60Hz, or 1500W Cooling Capacity
@ 200VAC/50Hz
1234960
Chiller,

00 M5C Pre Install.book

00 M5C Pre Install.book

…6.350 mm (1/4") flexible tube
Liquid Cooling System
Chiller Cooling Capacity 9 kW (27.3 kBtu/hr)
Chiller Static Pressure
(maximum)
827 kPa (120 psi)
Chiller Flow Rate (minimum) 9.46 lpm (2.5 gpm) @ 344.7 kPa (50 psi)
Chiller Water Temperature
Set-point

Preinstallation Manual Astrella Ultrafast Amplifier Laser System

Preinstallation Manual Astrella Ultrafast Amplifier Laser System

…Supply 3 m (10 ft.) 3 m (10 ft.)
Revolution Chiller 2.4 m (8 ft.) 3 m (10 ft.)
Vitara-S Power Supply
Vitara-S Controller
3 m (10 ft.) 3 m (10 ft.)
SDG Elite 3 m (10 ft.) N/A
1. The requirement needs to be met only if the water cooled chiller option is purchased.

Astrella Ultrafast Amplifier Laser System Preinstallation Manual

Astrella Ultrafast Amplifier Laser System Preinstallation Manual

…Supply 3 m (10 ft.) 3 m (10 ft.)
Revolution Chiller 2.4 m (8 ft.) 3 m (10 ft.)
Vitara-S Power Supply
Vitara-S Controller
3 m (10 ft.) 3 m (10 ft.)
SDG Elite 3 m (10 ft.) N/A
1. The requirement needs to be met only if the water cooled chiller option is purchased.

00 E-1000 PreInst.book

00 E-1000 PreInst.book

…temperature cooling fluid. Because the
properties of the cooling fluid are important for laser performance,
ensure that the conditions remain within the tolerance limits listed in
Table 1-2 on page 1-8 (operator's manual) at all times.
A closed-loop cooling system (chiller)

00 E-400 E-1000 Series Preinstall.book

00 E-400 E-1000 Series Preinstall.book

cooling system (chiller) should be used to obtain
consistent and stable laser performance. The chiller must be able to
remove up to 8.5 kW of heat, plus an additional 2 kW if the
liquid-cooled DC power supply option is used. The coolant composition for the closed-loop chiller is…

Paladin Advanced Preinstallation.book

Paladin Advanced Preinstallation.book

…2-4
Water Cooling ............................................................................................................ 2-4
Chiller ........................................................................................................................…

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

…of the Chiller Line Voltage for Paladin 8W/10W ............................. 3-6
Selection of the Chiller Line Voltage for Paladin 16/24/35 W ......................... 3-8
Cooling System.................................................................................................…

00 LMT Pre.book

00 LMT Pre.book

…planning recommendations.
Liquid Cooling
System
The LMC system requires an external, closed loop water cooling
system. This can be satisfied by a commercially available chiller, or
an existing cooling system. Coherent does not supply chillers, but
can recommend a model…