Search Results

1 - 12 of 143 Products for 'Density' Page 1 of 12 |

Density

LabMax PC Software Installation and Quick Start Guide

LabMax PC Software Installation and Quick Start Guide

LabMax PC Software Installation and Quick Start Guide
8
NOTICE!
Do not exceed the power/energy density limits
of the sensor.

ModeMaster PC User Manual

ModeMaster PC User Manual

…information is displayed on the Power Density plot
after calibration:
A. M2 Beam propagation factor for the R-beam whose
power density is being measured.
B. The Reference plane Power Density. This value
represents the Power Density at the Scan Head front
bezel. This…

COHR PowerMax-Pro USB-RS DS 1017 4.pdf

COHR PowerMax-Pro USB-RS DS 1017 4.pdf

…(mW)
Standard Mode <4
High Speed Mode <8
Snapshot Mode <16
Maximum Power Density (kW/cm2) 0.2 (150W)
Maximum Peak Power Density (kW/cm2) 14
Maximum Energy Density (J/cm2) 33 (10 ns; 1064 nm)
Rise & Fall Time (µs) 50
Detector Coating BB
Active…

PM135K100&5K200.p65

PM135K100&5K200.p65


Max Intermittent Power (< 5 min) (W) 1,500 4,000 7,500 7,500
Resolution (W) 1 1 1 1
Max Avg Power Density (kW/cm2)
* 26 26 26 26
Max Pulse Energy Density (J/cm2) 0.6 0.6 0.6 0.6
Response Time (sec) 45 45 45 45
Detector Coating Broadband Broadband Broadband Broadband…

Microsoft Word - kW Thermopile Damage Threshold.doc

Microsoft Word - kW Thermopile Damage Threshold.doc

…because the power density is too high, the water flow rate is too low, the total input power is above the maximum power rating, or a combination of these. Definition of Damage Threshold The damage threshold for a power sensor is defined as the maximum applied laser power density below which no…

COHR PowerMax-Pro DS 0917 3.pdf

COHR PowerMax-Pro DS 0917 3.pdf

…(mW)
Standard Mode <1
High Speed Mode <4
Snapshot Mode <9
Maximum Power Density (kW/cm2) 0.2 (150W)
Maximum Peak Power Density (kW/cm2) 14
Maximum Energy Density (mJ/cm2) 33 (10 ns; 1064 nm)
Rise & Fall Time (µs) 50 10 350 350
Detector Coating BB…

LabMax-Pro PC Software Installation and Quick Start Guide

LabMax-Pro PC Software Installation and Quick Start Guide

…meter must be OFF
before starting any of the tutorials described in
this section.
NOTICE!
Do not exceed the power or energy density
limits of the sensor.
The following illustration shows the areas of the graphical user
interface you will need to access while using…

COHERENT LMC 2016-2017 Catalog .pdf

COHERENT LMC 2016-2017 Catalog .pdf

…laser applications it is not laser power that does the work but power density. Using the ModeMaster PC, the point of
maximum power density can be quickly located. A convenient power density tuning screen displays power density as a pseudoanalog"tune bar,"giving real-time feedback as the laser…

07(IK14-10)p.53-57.fm

07(IK14-10)p.53-57.fm

…interface between the high
density I/O of the various logic and memory dies and the
lower density substrate (see figure 1). Plus, in some 3D
packages, this layer can be thicker to serve as both interposer
and a structural package element. High density conductive
microvias…

SureBlock XLF-2.pdf

SureBlock XLF-2.pdf

…to 50% transmission)
<10cm-1 <10cm-1 <10cm-1 <10cm-1 <10cm-1
Optical Density at Laser Line (each filter) > 4 >4 > 4 > 4 > 4
Expected System Optical Density > 8 > 8 > 8 > 8 > 8
Typical Transmission Efficiency (each filter) 60% 65% 70%…

SureBlock XLF-1.pdf

SureBlock XLF-1.pdf

…to 50% transmission)
<10cm-1 <10cm-1 <10cm-1 <10cm-1 <10cm-1
Optical Density at Laser Line (each filter) > 4 >4 > 4 > 4 > 4
Expected System Optical Density > 8 > 8 > 8 > 8 > 8
Typical Transmission Efficiency (each filter) 60% 65% 70%…

COHR PowerMax-Pro 15mm DS 0619 6.pdf

COHR PowerMax-Pro 15mm DS 0619 6.pdf

…<550 µW
<6 mW
Maximum Average Power Density (W/cm2)
with no Heat Sink
with Heat Sink
with Water-cooled Heat Sink2
25
50
300
Maximum Peak Power Density (kW/cm2) 14
Maximum Energy Density (mJ/cm2) 33 (10 ns; 1064 nm)
Rise & Fall Time…