Search Results

Refine
13 - 24 of 39 Products for 'J 3 Operator Manual' Page 2 of 4 |

J 3 Operator Manual

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

…and Specifications
1 - 3
Electrical Safety The Paladin Advanced Mode Locked UV laser system contains
potentially hazardous voltages inside the protective enclosures of
the power supply and laser head. Do not open the protective enclosures. Do not operate the laser system without…

Diamond J-3-5 Series OEM Lasers Preinstallation Manual, Rev. AA

Diamond J-3-5 Series OEM Lasers Preinstallation Manual, Rev. AA


Table 4-1 provides a description of the LED indicator. Critical
signals, which control laser power, are the pulse width and pulse
period. Typical laser output power for various operating pulse
widths and periods is shown in Section Five: Operation in the operator's manual.

Diamond J-3 Series OEM Lasers Preinstallation Manual, Rev. AC

Diamond J-3 Series OEM Lasers Preinstallation Manual, Rev. AC

…Provides a low power RF simmer pulse to ensure that the laser
will start after long periods of being off.
· Contains embedded sensors which support fault isolation.
Further description of this capability is found in Appendix A:
Embedded Diagnostics in the operator's manual.

COHR DIAMOND J-3-5 COlaser DS 0617 2.pdf

COHR DIAMOND J-3-5 COlaser DS 0617 2.pdf

…Gas Requirements12 (cfm) >2
1 All specifications apply when the product is operated in accordance with the guidelines defined in the operators manual.
2 Measured at 1 kHz PRF, 60% duty cycle.
3 Output stability specification may not be met at lowest power or at acoustic resonances.…

COHR DIAMOND J-3 DS 0617 1.pdf

COHR DIAMOND J-3 DS 0617 1.pdf

…Altitude 2000 m (6500 ft.)
1 All specifications apply when the product is operated in accordance with the guidelines defined in the operators manual.
2 Measured at 10 kHz PRF, 60% duty cycle.
3 Output stability specification may not be met at lowest power or at acoustic resonances.…

Diamond J-5 Series OEM Lasers Preinstallation Manual, Rev. AC

DIAMOND J-5 Series OEM Laser Operator's Manual
3 - 22
4. Insert fork-type lifting device between the laser and the box,
then lift the laser out of the box (Figure 3-9).
Figure 3-9. Lifting the Laser

DIAMOND J-5V Series OEM Lasers Preinstallation Manual, Rev. AA

DIAMOND J-5V Series OEM Lasers Preinstallation Manual, Rev. AA

Operator's Manual Preliminary: December 18, 2015 1:00
1 - 6
Labeling Figure 1-2 shows the positions of all the labels located on the
DIAMOND J-5V Series laser systems.
a. Output End
b. Interface End
Figure 1-2. Label Placement
1
2
3 4
5
4
3

Diamond J-2 Series OEM Lasers Preinstallation Manual, Rev. AB

Utility Requirements and System Installation
3 - 3
Confirm Laser
Environment
The laser must be installed and operated in a temperature and
humidity-controlled environment. The operating temperature must
be 5 - 45ºC (41 - 113ºF). The humidity must be 5 - 95%,

COHR DIAMOND J-5 DS 1117 1.pdf

COHR DIAMOND J-5 DS 1117 1.pdf

…Altitude 2000 m (6500 ft.)
1 All specifications apply when the product is operated in accordance with the guidelines defined in the operators manual.
2 Measured at 10 kHz PRF, max. duty cycle.
3 Output stability specification may not be met at lowest power or at acoustic resonances.…

COHR DIAMOND C 30 C 30 DS 0619 3.pdf

COHR DIAMOND C 30 C 30 DS 0619 3.pdf

…material
and workmanship. The warranty does not apply to any unit damaged by accident, abuse or operation in a manner inconsistent with the procedures and specifications outlined in the manual supplied with the laser.
The Diamond C-30 & C-30+ CO2
laser is a component that does not…

DIAMOND C-30+ Air-Cooled OEM Laser Preinstallation Manual, Rev. AA

DIAMOND C-30+ Air-Cooled OEM Laser Preinstallation Manual, Rev. AA

…2 of 3)
3 3
3
5
PATENT: www.coherent.com/patent
1280 BLUE HILLS AVE, BLOOMFIELD, CT 06002
THIS PRODUCT IS INTENDED FOR USE SOLELY AS A COMPONENT OF AN OEM
PRODUCT AND DOES NOT COMPLY WITH CDRH PERFORMANCE STANDARDS,
21 CFR SUBCHAPTER J, IF OPERATED AS A…

DIAMOND C-55 Liquid-Cooled OEM Laser Preinstallation Manual, Rev. AG

DIAMOND C-55 Liquid-Cooled OEM Laser Preinstallation Manual, Rev. AG

…Labels (Sheet 3 of 4)
PATENT: www.coherent.com/patent
1280 BLUE HILLS AVE, BLOOMFIELD, CT 06002
THIS PRODUCT IS INTENDED FOR USE SOLELY AS A COMPONENT OF AN OEM
PRODUCT AND DOES NOT COMPLY WITH CDRH PERFORMANCE STANDARDS,
21 CFR SUBCHAPTER J, IF OPERATED AS A STAND-ALONE…