Search Results

Refine
25 - 36 of 39 Products for 'J 3 Operator Manual' Page 3 of 4 |

J 3 Operator Manual

DIAMOND C-60+ Series OEM Lasers Preinstallation Manual, Rev. AA

DIAMOND C-60+ Series OEM Lasers Preinstallation Manual
22
1. Identification Label
2. Danger of Laser Radiation Label
3. Tamper Proof Label
4. Voltage Warning Label
Figure 2-7. Labels
PATENT: www.coherent.com/patent
1280 BLUE HILLS AVE, BLOOMFIELD, CT 06002…

DIAMOND C-55 Air-Cooled OEM Laser Preinstallation Manual, Rev. AG

DIAMOND C-55 Air-Cooled OEM Laser Preinstallation Manual, Rev. AG

…(Sheet 2 of 3)
5
PATENT: www.coherent.com/patent
1280 BLUE HILLS AVE, BLOOMFIELD, CT 06002
THIS PRODUCT IS INTENDED FOR USE SOLELY AS A COMPONENT OF AN OEM
PRODUCT AND DOES NOT COMPLY WITH CDRH PERFORMANCE STANDARDS,
21 CFR SUBCHAPTER J, IF OPERATED AS A STAND-ALONE…

DIAMOND C-20 and C-30 Liquid-Cooled OEM Lasers Preinstallation Manual, Rev. AF

DIAMOND C-20 and C-30 Liquid-Cooled OEM Lasers Preinstallation Manual, Rev. AF

…(Sheet 3 of 4)
8
PATENT: www.coherent.com/patent
1280 BLUE HILLS AVE, BLOOMFIELD, CT 06002
THIS PRODUCT IS INTENDED FOR USE SOLELY AS A COMPONENT OF AN OEM
PRODUCT AND DOES NOT COMPLY WITH CDRH PERFORMANCE STANDARDS,
21 CFR SUBCHAPTER J, IF OPERATED AS A STAND-ALONE…

DIAMOND Cx-10 Series OEM Laser Preinstallation Manual, Rev. AB

DIAMOND Cx-10 Series OEM Laser Preinstallation Manual, Rev. AB

…LABEL
Figure 1-5. Location of Safety Labels (Sheet 2 of 3)
This product is intended for use solely as a component of an OEM product and does not comply
with CDRH performance standards, 21 CFR subchapter J, if operated as a stand-alone instrument
MFG.PARTNUM.SERIAL
1280…

PL-501 Book.book

PL-501 Book.book

…The information in this Operator's Manual is in compliance with the following
standards for Light-Emitting Products IEC 60825-1 / EN 60825-1 "Safety of laser
products - Part 1: Equipment classification and requirements" 21 CFR Title 21
Chapter 1, Subchapter J, Part 1040 "Performance…

Vitara Preinstall.book

Vitara Preinstall.book


operation and associated electronics must select ground references.
Integrated
Pump Lasers
Some versions of the Vitara system incorporate a Coherent
Verdi-GTM laser as a subcomponent. The beam from this laser is
hazardous. Refer to the Verdi-G Operator's Manual for…

Libra PreInstallation.book

Libra PreInstallation.book


operation and associated electronics must select ground references.
Component
Lasers
The Libra system incorporates Coherent VitesseTM and EvolutionTM
lasers as components. The beams from these lasers are hazardous.
Refer to their respective Operator's Manuals for…

COHR DiamondJ-2 DS 0518 2.pdf

COHR DiamondJ-2 DS 0518 2.pdf

…Altitude 2000 m (6500 ft.)
1 All specifications apply when the product is operated in accordance with the guidelines defined in the operators manual.
2 Measured at 10 kHz PRF, 70% duty cycle.
3 Output stability specification may not be met at lowest power or at acoustic resonances.…

COHR DiamondJ-5 DS 0119 1.pdf

COHR DiamondJ-5 DS 0119 1.pdf

…Altitude 2000 m (6500 ft.)
1 All specifications apply when the product is operated in accordance with the guidelines defined in the operators manual.
2 Measured at 10 kHz PRF, max. duty cycle.
3 Output stability specification may not be met at lowest power or at acoustic resonances.…

Lasers-for-Life-Sciences-Product-Guide FORMFIRST.pdf

Lasers-for-Life-Sciences-Product-Guide FORMFIRST.pdf

…Modulation Input SMB, 50 Ohm, 0 to 5V
Digital Modulation Input3 SMB, 50 Ohm, 0 to 3V
Warm-up Time (minutes)(from cold start) <2
OBIS Connection Software2 Included on USB drive with user manual
Power Consumption (W)(typical) 5
Power Consumption (W)(maximum) 110

COHR DIAMOND E-1000 DS 0817 1.pdf

COHR DIAMOND E-1000 DS 0817 1.pdf

…material
and workmanship. The warranty does not apply to any unit damaged by accident, abuse or operation in a manner inconsistent with the procedures and specifications outlined in the manual supplied with the laser.
The Diamond E-1000/E-1000i CO2
laser is a component that does not…

COHR DIAMOND E-1000 DS 1118 1.pdf

COHR DIAMOND E-1000 DS 1118 1.pdf

…material
and workmanship. The warranty does not apply to any unit damaged by accident, abuse or operation in a manner inconsistent with the procedures and specifications outlined in the manual supplied with the laser.
The DIAMOND E-1000/E-1000i CO2 laser is a component that does not…