Search Results

Refine

Result Type

1 - 8 of 8 Products for 'Laser Flash Lamp' Page 1 of 1 |
  • 1

Laser Flash Lamp

Excimer laser technology trends

Excimer laser technology trends

…of a standard PLD laser filled with 248 nm premix gas.
The low pulse count translates into a lifetime for the laser
tube of about 10 years and also into long exchange cycles for
the resonator optics of 3-5 years, as indicated in figure 1.
As the excimer laser in a PLD laboratory…

Industrial Laser Solutions - March/April 2016

Industrial Laser Solutions - March/April 2016

…but with
lower cost of operation and much longer service intervals than
other laser types, such as flash lamp-pumped Nd:YAG.
With first-generation fiber lasers based on single-emitter laser diode pumps, all the numerous pump components
are typically fused together to maximize…

Photonics Spectra - September 2017

Photonics Spectra - September 2017

…of molecules, complexes and other systems. However, this steady state data contains very limited temporal information. The use of flash lamps and pulsed lasers can often extend linear spectroscopy to show the timescale over which one state of the system evolves into another. While this is obviously…

Flyer KLS 2017.pdf

Flyer KLS 2017.pdf

…at 3ms max.1) [kW] 0.6 - 0.3 4 6 3 5.5 6
Average power max.1) [W] 15 100 150 220 220 250
1) Measured without beam delivery with new flash lamp
Line Power
Configuration 3-phase + ground ± 10%
Multitap transformator for 3x200 V, 208 V, 230 V, 380 V, 400V, 480 V
Power…

Flyer FLS A EN 2017.pdf

Flyer FLS A EN 2017.pdf


Peak power at 1 ms max. 1) 20 kW 16 kW 50 kW
Average power max. 1) 150 W 200 W 500 W
1) Measured without beam delivery with new flash lamp
Line Power
Configuration 3-phase +
ground ±10%
3-phase +
ground ±10%
3-phase +
ground ±10%
Multitap…

LaserCam-HR II User Manual

LaserCam-HR II User Manual

…0.04% to
0.05% typical. The LDFP is made of laser grade filter glass that
minimizes interference fringes--refer to "Fringes" (p. 4-5)--and
does not distort the beam image. The LDFP limits room light, instrumentation lights, and flash lamp light from reaching the camera
sensor.…

Flyer SLS 200 EN 2017.pdf

Flyer SLS 200 EN 2017.pdf

…kW Average power max. 2) 10 W 50 W 220 W 300 W 1) Min. pulse length for controlled pulse is 0.5 ms 2) Measured without beam delivery with new flash lamp Fiber Optic Beam Delivery Number of outputs 1 port 1-6 ports 1-6 ports 1-3 ports Modes n/a energy or time sharing or combined Fiber core diameter…

MerMAIDs: a family of metagenomically discovered marine anion-conducting and intensely desensitizing channelrhodopsins

MerMAIDs: a family of metagenomically discovered marine anion-conducting and intensely desensitizing channelrhodopsins

…OPOTEK),
which was pumped with the third harmonic of a Nd:YAG laser (BrilliantB,
Quantel, Les Ulis, France). The laser energy was adjusted to 5 mJ/shot and pulse
duration of 10 ns. A 150-W xenon lamp (Osram, München, Germany) was used to
monitor changes in absorption.…

Please Read Before Continuing

Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.


I have read the terms and conditions