…purge line, or
by splitting and regulating an existing purge line to provide
good flow to both laser and beam delivery components.
The direction of fluid flow is first into the laser head module and
then through the RF power module (see Figure…
…Life Sciences VLM Miniature Diode Laser Modules Circluar, Elliptical and Line Generating beam miniature diode laser modules provide the smallest package size and best value. Included inside every module are complete electronics to manage the constant power laser drive with a closed-light loop based…
…Requirements on coolant flow rate are listed in Table 3-2 (p. 28). To
prevent damage to the laser head or the RF power module, the gauge
pressure of the coolant at the laser head and at the RF power module
must not exceed 100 psig (i.e. the gauge pressure - the difference
purge gas line between the laser head and RF
head and RF
1/4 inch (6 mm) OD Tee for splitting the purge gas
tubing at the laser head and RF power module
3 Some energy and spectrum modulation possible in the range 730 nm to 870 nm.
4 Assuming 250 µJ, 400 nm pump from SHBC. Scales linearly with pump in range 0.3 mJ to 1 mJ.
Computer-Controlled, Line Narrowed, Optical Parametric Amplifier Accessory…
…Developer's Kit Elliptical Beam and Uniform Line Generating Laser Modules The Coherent StingRay Developer's Kit enables end-users, integrators, researchers, and educational labs to quickly evaluate 3D applications in which structured light lasers provide solutions. Users can quickly configure,…
…· No modulation input required
Signals for Modulation
Laser power can be modulated by using an external signal. A different option must be
selected at the time the order is placed.
In addition to the VIN
(Power) and VIN
Ground lines, lasers equipped with modulation
…for a given spot diameter or line thickness. Laser vision is also used to check the alignment of wheel and tire during mounting on to cars on the production line, e.g., relative to the steering mechanism. Here the laser module projects a pattern of parallel lines on to the front wheel(s) and the…
Diode Laser Modules
· Ultra-low noise (ULN)
· RMS noise <0.06% for bandwidths of 10 Hz to 10 MHz
· Circular beam
· No mode-hop noise
· No warm-up period
· Wavelength 635 nm with 5 mW CW power
· Long lifetime
…given spot diameter or line thickness.
Laser vision is also used to check the alignment of wheel and tire during
mounting on to cars on the production line, e.g., relative to the steering
mechanism. Here the laser module projects a pattern of parallel lines on to
…lines to the modulation
source. (other connectors or wires are only available upon
2. Modulation Connection: VMod Blue wire, VMod Gnd
To pulse and/or to modulate the laser power:
1. Supply the laser with power--refer to "Turning the Laser ON"…
laser diode aging.
with the CUBE
The equivalent of a Laser operating through an AOM can be
achieved by using the CUBE Laser in Pulse mode. The ON-OFF
control line connects to the Digital modulation input (SMB