Round Module User Manual
· Laser module will begin to temperature stabilize.
· Laser diode will not emit light for 20 seconds after power has been applied.
· Use of TTL line does not affect temperature control
5.1 Maintenance and Inspection
Laser module can be operated with or without USB communication port.
User Startup Procedure:
· Properly mount laser module on a heat sink
· If necessary, connect mini USB interface cable
· Connect power supply
Laser Module Startup Process:
Laser module controller…
Compact Laser Diode Module User Manual
· Save to flash and exit the setting menu
Save to Flash
All the setting parameters will be saved to flash memory. So the laser will keep this
setting even when the unit is reset or repowered.
4.4 Operation via…
…Laser Modules and Systems 7
Diode Laser Systems
CUBE FP 20-27
Diode Laser Modules
ULN 31- 32
Cross-Hair Line Generators 33
Focusable Line Generator Modules 34-35
Line Generator Diode Laser Modules 36-37
Miniature Diode Laser…
…y r e s e a r c h SMART PLUG&PLAY LASER MODULES ACEA has responded to this need with a novel benchtop cytometer line, the NovoCyte, which features a high degree of internal modularity. «It's a very flexible platform that allows us to include just the laser wavelengths specifically requested by…
…the volume Bragg gratings that narrow
the spectral line of the diode laser to a
range that is useful for the particular application, custom package design that
permits tunability of the spectral line
emitted from the module, and the custom optics that form the beam to a precise…
Magnum II lasers with direct modulation can emit light if the modulation wire is left unconnected or if it is connected to the ground slot.
To emit light, Magnum II lasers with reverse modulation require
+ 5 VDC voltage at the modulation input (pins 9 and 1 of the…
& product line manager of custom fiber lasers at Coherent, Tampere,
ing of difficult materials
FIGURE 2. Cross-sections show the weld seam for 1.25-mm-thick zinc-coated steel
processed using a fiber laser without a gap between the…
…pump module as shown in
Figure 3-13. Use the 8 mm torque wrench from the Paladin
Advanced Maintenance Kit. Align the black line on the fiber
so it points 180° away from the middle of the pump module.
Discard protective cap
Figure 3-13. Attach the Fiber to the Pump Module…
…photodetector while the laser was switched between two
wavelengths. Two photodetectors were used to detect the secondary output beams, one for
each wavelength. The internal pulse width modulation (PWM) of the DLP was used in this
experiment to dither the "white" lines of pixels.
The laser system was designed to enable removal of the RF power
module with only access from the top and service end of the laser
The laser system incorporates a sealed laser resonator assembly
compartment, which by design requires no laser gas exchange…
DIAMOND J-2 Series OEM Lasers Preinstallation Manual
3 - 34
The direction of fluid flow is first into the laser head module and
then through the RF power module (see Figure 3-16).
Figure 3-16. Interface Connectors End View
Table 3-5. J-2…