Search Results

1 - 6 of 6 Products for 'Laser Pen' Page 1 of 1 |
  • 1
Related Categories: Obis Commands | Blog | Avia 532 45 | Powermeter | 1053

Laser Pen

GUI 3.88 Revision History.pdf

GUI 3.88 Revision History.pdf

…firmware version to install Added a lookup table button for HyperNX When firmware upgrade tool cannot upload a file to the laser it now suggests power cycling the laser and trying again Removed "32-bit" from installation message for SQL CE to avoid confusing 64-bit users When adding extra points…

Business Conduct Policy

…may not serve as a member of the Board of Directors, or in a management capacity, or as a consultant to any business enterprise that is in the laser business or otherwise has a business relationship with Coherent without the prior disclosure to and written approval of the chief executive officer…

Microelectronics

Microelectronics

…with a single laser pulse. And at 300 pulses per second, this “single pulse” laser process can generate 18,000 circuits/minute. The circuits are fabricated by vapor deposition of a uniform layer of metal (e.g., Au, Ag, Cu, Al) onto a flexible substrate such as PET, polyimide, PEN, or PMMA. The…

Coherent BioRay Operator's Manual

Coherent BioRay Operator's Manual

Converting a BioRay Laser to FC
B - 5
8. Add alignment marks on the fiber body and the laser body as
shown below (you can use a felt-tip marker or a ballpoint pen
on a small piece of tape). Note: The alignment marks will be
used in step 11 (p. B - 10) of the "Optimizing the…

Excimer LLO 2014.pdf

Excimer LLO 2014.pdf

…terephthalate (PET) and polyethylene naphthalate (PEN) show low water absorption, high
chemical and mechanical resistance, and good dimensional
stability [8]. The polarization-changing birefringence of the
semi-crystalline PET and PEN backplanes is of no concern
in the case of…

book.book

book.book

StingRay/BioRay Lasers Operator's Manual
2 - 26
15. Add alignment marks on the fiber body and the laser body as shown in
Figure 2-43. Use a felt-tip marker or a ballpoint pen on a small piece of tape. The
alignment marks are used to realign the fiber body with the laser body.…