…Class A Radiated Emissions
Class A Conducted Emissions
Power Line Harmonics
Power Line Voltage Fluctuation and Flicker
EMC Standard for Immunity per:
Electrostatic Discharge -…
…environment. Vibrations can be
transmitted to the laser head from the surface on which it rests,
causing beam pointing instability and power fluctuations. To minimize vibrations, the laser head should be placed on a stabilized
optical table and isolated from mechanical contact with…
…after January 1, 1997 Features · Protects and extends tube life · Improves laser performance and stability · Powered and controlled from laser power supply · Isolates laser from fluctuations of water quality, flow, pressure, and temperature · Self-priming pump for easy start-up Superior Reliability…
…all-solid-state, Verdi-pumped ultrafast system is extremely stable. In continuous operation
for more than 48 hours, the DFG 9850 produced power fluctuations of less then ±5%.
Ease of Use
Tuning the DFG is a relatively simple process. Typical tuning ranges, from 2.5 m to beyond
…Do not apply AC power to the power supply chassis; this will
activate the LBO crystal heater. Programming the crystal heater
improperly will permanently damage the crystal. Such damage
will not be covered under warranty.
The Revolution power supply is compatible…
…doubled crystal lasers such as Nd:YAG causing mode
and hence power fluctuations, cannot occur. This is
one of the major reasons for the excellent noise
characteristics of OPSLs.
In addition to power scaling and power adjustment,
OPSL technology enables wavelength scaling. By…
* Protects and extends tube life by isolating the laser from fluctuations of water quality, flow, pressure, and temperature
* Improves laser performance and stability
* Powered and controlled by the laser power supply which eliminates the need for a separate electrical service
1 Power fluctuation at full rated power for 5 hours.
2 Beam diameter (1/e2), for options with no beam expander, beam diameter is measured at a distance of 20 mm from output aperture.
3 Other beam diameters are available on request.
4 At the lowest PRR and full rated power.
…and power fluctuations. To minimize vibrations,
the laser head should be placed on a stabilized optical table and
isolated from mechanical contact with other equipment.
The Innova Sabre ion laser is shipped in three crates: one contains
…output power) depends
considerably on the beam quality of the pump laser.
Additionally, THz generation and - more so - its higher
harmonics are negatively affected by amplitude noise in
the pump beam because they are non-linear processes
where any input power fluctuation…
…while for instrumentation and measurement needs, wavelengths from 635 nm to 830 nm are available.
Temperature, wavelength and power
Temperature fluctuations can adversely affect
diode lasers. For example, at 50°C typical red diode
lifetimes are approximately 6,000 hours. However,…
continuous wave laser beams. It allows one to measure power noise, frequency noise,
and beam pointing fluctuations in a Fourier frequency band from 1 Hz to 100 kHz as well
as power noise at radio frequencies (RF) up to 100 MHz and spatial beam quality. The