…the interlock chain.
Guidance rail or tube for laser fibers (minimum bending
radius 10 cm or 4 inches). The laser fibers need to be protected and covered against mechanical forces.
The minimum bending radius of the chiller water hoses is:
13 cm or 5.1 inches).…
…90C Applications Application Process Material Life Sciences Scientific Confocal Microscopy Flow Cytometry Laser Doppler Velocimetry Fluorescence Excitation Dye Laser Ti:Sapphire Laser --> Features & Benefits Power Specifications 1 90C-A3 90C-A4 90C-A5 90C-A6 90C-K Wavelength (nm) Multiline…
…UV Laser Preinstallation Manual
3 - 12
Care must be taken in the next steps to attach the correct optical
fiber to the pump module package. Keep the minimum 15_cm
bend radius as the fibers are pushed through the power supply.
If the laser is an…
longest dimension for this comparison.
In Depth: Laser Beam Size
The boundaries of optical beams are not
clearly defined and, in theory at least, extend
to infinity. Consequently, the dimensions of
laser beams cannot be defined as easily as the
Radius Power Supply Radius Control Box
nterl ck R
Radius 635 specifications are equal to or better than most HeNe lasers in most applications. Radius lasers
…outside the laser cavity the beam is analyzed. There are three basic
regions each with its own mode characteristics, the Near Field, the Rayleigh Range, and the Far Field.
For diffraction-limited beams, the Rayleigh Range ZR is determined by its waist radius R0 and laser
…OBIS Laser Box 34-35
OBIS Accessories 36-41
OBIS Scientific Remote 42-43
BioRay FR 50-53
Structured Light Flat Top Projector 54-57
CUBE FP 66-73
Radius Lasers 74-75
…ultrafast laser pulses, chirped volume holographic gratings (VHGs) offer both high damage threshold and an ultracompact footprint for dramatic improvements in chirped pulse amplification (CPA) laser systems. JAMES CARRIERE and FRANK HAVERMEYER Over the last two decades, high-power ultrafast lasers…
…(3.0 in.) Min. Bend Radius Laser Head - Rear View Laser Head - Rear View (PZT option) Laser Head - Front View Laser Head - Side View Laser Head - Bottom View Features · Single-longitudinal-mode output · Optical noise 25%) · Ultra-long-life AAATM (Aluminum-free Active Area) laser diode material ·…
Ensure the umbilical has a bend radius of 5 inches or greater.
Excessively tight fiber bends (less than a 5 inch radius) can cause
After installing the laser head and power supply in accordance…
Min. Bend Radius
Laser Head - Top View
Laser Head - Side View
Laser Head - Bottom View
Laser Head - Rear View
Laser Head - Front View
…demonstrates that the CO laser produces even lower residual stress than CO2
cutting, yielding a stronger cut piece, together with a wider process window for the manufacturer.
Figure 5. A CO laser with only 9W of output power produced this clean, curved cut (6 mm radius circle) in thin…