1 - 10 of 232 Search Results for Scan Head
|
|
|
5.
Book.book
(PAGE 202 OF 214)
|
|
…indicator is on.
Scan Head is not detected. The Measurement wheel may not be
turning. Scan Head may not be properly
connected to the controller.
Verify that the wheel is rotating by
looking through the Scan Head input lens.
Verify that the 37-Pin Scan Head
connector is…
|
|
|
|
|
6.
Book.book
(PAGE 30 OF 214)
|
|
…small dot symbol
within the small circle symbol (adjusts the scan head so the input
beam is parallel with the scan head optical axis) and the dot and
circle both to the center of the alignment target (adjusts scan head so
the input beam is on its optical axis).
5. The micrometer…
|
|
|
|
|
7.
Book.book
(PAGE 203 OF 214)
|
|
…proper alignment with Near-Ir laser
source.
Scan Head alignment is not adequate. Utilize the Scan Head Flip Mirror and an
IR viewing card to obtain adequate alignment. Place IR card close to laser source
and adjust Scan Head alignment to reflect
the beam on the card. Review…
|
|
|
|
|
8.
Book.book
(PAGE 70 OF 214)
|
|
…
3 - 11
J. Current Relative Power - The current relative power
reading is the result of the user-entered power and the
current Scan Head detector output.
K. Properties Panel Tool Tips - This pane will display a
description of the currently-selected Properties Panel
function…
|
|
|
|
|
9.
Book.book
(PAGE 35 OF 214)
|
|
…been written to the scan head
EEPROM. When you restart the ModeMaster PC software, the
appropriate default parameters will be reset.
7. The new accessory has now been properly installed into the
scan head.
The accessories are contained in the scan head and not the
computer…
|
|
|
|
|
10.
Book.book
(PAGE 81 OF 214)
|
|
…the Scan Head is adjusted to a 45°
azimuth angle, X is horizontal distance and Y is vertical
distance. Value of 0 indicates beam is exactly on the
optical axis.
G. Distance (in counts) between beam axis and instrument
axis at the rotating drum rear cut plane. When the Scan
…
|
|
