Search Results

Refine
1 - 12 of 18 Products for 'User Manual Obis' Page 1 of 2 |

User Manual Obis

OBIS-Single-Laser-Remote-Data-Sheet.pdf

OBIS-Single-Laser-Remote-Data-Sheet.pdf

…0 to 5V
Digital Modulation Input2 SMB, 50 Ohm, 0 to 3V
Warm-up Time (minutes)(from cold start) <2
OBIS Connection Software3 Included on USB drive with user manual
Power Consumption (W)(typical) 1 (laser not included)
Power Consumption (W)(maximum) 2 (laser not included)…

COHR OBIS SingleLaserRemote DS 0317 1.pdf

COHR OBIS SingleLaserRemote DS 0317 1.pdf

…to 5V
Digital Modulation Input2 SMB, 50 Ohm, 0 to 3V
Warm-up Time (minutes) (from cold start) <2
OBIS Connection Software3 Included on USB drive with user manual
Power Consumption (W) (typical) 1 (laser not included)
Power Consumption (W) (maximum) 2 (laser not included)…

COHR OBISfamily DS 1219 3.pdf

COHR OBISfamily DS 1219 3.pdf


5 See mechanical drawing for exit beam location.
6 Typically 85% of heat load through the base plate. See Users Manual for more detail.
7 Non-Condensing. See User Manual for more detail.
8 For LS versions laser head baseplate temperature needs to be maintained at 40°C.

book.book

book.book

…1222894) for StingRay and BioRay lasers is shown in
Figure 6-10. TheAdapter Plate hole pattern allows the user to adapt the StingRay laser
to the same mounting hole pattern as an OBIS LX/LS laser.
This Adapter Plate works with the StingRay/BioRay Heat Sink Mount (P/N 1222896)
as…

COHR OBISfamily DS 0119 3.pdf

COHR OBISfamily DS 0119 3.pdf

…clip levels.
4 Typical power-on delay 0.1 minutes.
5 Typically 85% of heat load through the base plate. See Users Manual for more detail.
6 Non-Condensing. See User Manual for more detail.
7 Fiber FC/APC connector output not compatible for patchcord-to-patchcord connection.

OBIS CellX Laser Combiner

OBIS CellX Laser Combiner

…Kit, includes CellX and all parts below 1323532 Accessory Kit for CellX (Alignment Tools, Interlock Plug, USB Cable, Coherent Connection, User Manual) 1321203 Accessory, Objective Lens, OL10-UV 10 µm Focus, CellX 1365935 Accessory, Objective Lens, OL15-UV 15 µm Focus, CellX 1383130 Accessory,…

COHR OBIS CellX DS 0117 3.pdf

COHR OBIS CellX DS 0117 3.pdf

…2 OEM Product - does not comply with CDRH 21CFR 1040.10 and 1040.11 without appropriate integration.
3 Typically 85% of heat load through the base plate. See Users Manual for more detail.
4 Non-Condensing. See User Manual for more detail.

Rear View
Top View
Front View

COHR OBIS ScientificRemote DS 0317 1.pdf

COHR OBIS ScientificRemote DS 0317 1.pdf

…5V
Digital Modulation Input3 SMB, 50 Ohm, 0 to 3V
Warm-up Time (minutes) (from cold start) <2
OBIS Connection Software2 Included on USB drive with user manual
UTILITY AND ENVIRONMENTAL REQUIREMENTS
Power Consumption (W) (typical) 5 (without lasers)
Power Consumption…

OBIS LaserSafety Installation QSG 11-85-44 9 RevAF COVERS.fm

OBIS LaserSafety Installation QSG 11-85-44 9 RevAF COVERS.fm

…of this Guide.Also see the
Coherent OBIS LX/LS Operator's Manual.
Note that, in this configuration, the OBIS laser is
intended for use in OEM equipment. The OBIS
automatically starts laser emission after DC power is
supplied. The user is responsible for compliance with all…

COHERENT CORPORATE OVERVIEW

COHERENT CORPORATE OVERVIEW

pg. 8 |
OBIS Laser System Includes:
Laser Remote Laser-to-Remote
Cable (SDR)
Power Supply
and USA Cord
Bolts and
Washers
Mounting Hardware
for Remote
USB Cable Includes User
Manual and
Software
Laser Safety
Pamphlet
Interlock…

COHR OBISfamily DS 0818 8.pdf

COHR OBISfamily DS 0818 8.pdf


5 See mechanical drawing for exit beam location.
6 Typically 85% of heat load through the base plate. See Users Manual for more detail.
7 Non-Condensing. See User Manual for more detail.
8 For LS versions laser head baseplate temperature needs to be maintained at 40°C.

COHR OBIS LaserBox DS 0618 1.pdf

COHR OBIS LaserBox DS 0618 1.pdf

…LED for each Laser
Warm-up Time (minutes) (from cold start) <2
Coherent Connection Software for PC Included on USB drive with user manual
Safety Key switch and interlock
UTILITY AND ENVIRONMENTAL REQUIREMENTS
Power Consumption (W) (typical) 5 (without lasers)