Search Results

Refine

Result Type

1 - 7 of 7 Products for 'Wiring Diagrams' Page 1 of 1 |
  • 1

Wiring Diagrams

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

2011-Diode-Laser-Modules-and-Pattern-Generators-Catalog.pdf

…(Green
*)
PIN 7 Modulation Input (Blue
*)
PIN 8 Reserved for Calibration (Violet
*)
PIN 9 Diode Temperature Monitoring (Gray
*)

*Wire
color on optional Micro DB 9 cable
Yellow LED
(laser diode "ON")
DB-9 Connector
Adjustment
Potentiometer
No Connector…

Revolution High-Power Q-Switched Laser System Preinstallation Manual

Revolution High-Power Q-Switched Laser System Preinstallation Manual

…connect the interlock switch, remove the supplied external jumper plug, and either
re-wire according to the wiring diagram in Figure 1-3, or use a
similar connector. Wire the external interlock switch normally
closed, such that if the door or safety device and the switch opens,

Vitara Preinstall.book

Vitara Preinstall.book

…displays the pin diagram for the interlock connector. The
interlock defeat shorts pins 1 and 2 as well as pins 6 and 7.
Install the external switch between pins 1 and 2 of the connector,
and install a short between pins 6 and 7. Figure 3-7 shows a wiring
diagram for the switch.…

Verdi preinstall.book

Verdi preinstall.book

…ends of the wires to an interlock switch. You
can use many types of switches. The switch must be of a type
that has its contacts closed when it is safe to operate the laser
and open when it is not safe.
4. Figure 1-5 shows the wiring diagram for the switch. One wire
runs…

book.book

book.book

Section Six: Parts and Accessories
6 - 15
Table 6-2 lists the RS-232 signal assignments and wire colors.
Table 6-3 lists the communication settings for RS-232:
Hirose Connector
Figure 6-31 shows the dimensions for cable assembly with a 12-Pin Hirose Connector
(P/N…

00 M5C Pre Install.book

00 M5C Pre Install.book

…Figure 3-1. Installation Block Diagram
Blower
*
Exhaust
Exhaust
Sensor
Input
LMT System
Return
Supply
Chiller
*
Facility Wall
External Fan
Relay
System Power
(Customer-supplied wiring)
Network connection

Industrial Laser Solutions - March/April 2016

Industrial Laser Solutions - March/April 2016

…been described in this magazine several times in the past [1, 2]. Briefly, the cladding material is introduced onto the part surface in powder or wire form, and the laser is used to selectively melt this material, as well as the substrate, to a very small depth in order to fuse the two. Laser…