Preinstallation ManualAVIA 355/355-X Laser 5100 Patrick Henry Drive Santa Clara, CA 95054 AVIA 355/AVIA 355-X Laser Operator's Manual ii This document is copyrighted with all rights reserved. Under the copyright laws, this document may not be copied in whole or in part or reproduced in any other media ... Related Searches:avia | chiller | avia 7000
Preinstallation ManualAVIA 266 Laser 5100 Patrick Henry Drive Santa Clara, CA 95054 AVIA 266 Laser Operator's Manual ii This document is copyrighted with all rights reserved. Under the copyright laws, this document may not be copied in whole or in part or reproduced in any other media without the ... Related Searches:avia operator manual | bnc connector | water chiller
AVIA 355/AVIA 355-X Laser Preinstallation Manual 16 ECHO Mode The AVIA 355 provides an echo mode in which each character transmitted to the laser is echoed to the host. This feature can be turned on or off using the ECHO command (refer to Table 11). PROMPT Mode The AVIA 355 provides an prompt mode ...
AVIA 355/AVIA 355-X Laser Preinstallation Manual 28 PRINT SPOT STATUS:nn ?SPS:nn nn= The spot number of the THG crystal spot you wish to check. 0 if the spot status is GOOD. 2 if the spot status is USED. PRINT TEMP SERVO TIGHT LOCK STATUS ?TSTLS Indicates is all temperature servos are within 0.1ºC ... Related Searches:thg crystal
AVIA 266 Laser Preinstallation Manual 22 PRINT DIODE1 HOURS ?D1H Returns the number of operating hours on laser diode 1. PRINT DIODE1 OPTIMIZE ?D1O Returns the status of the diode 1 optimization power routine. 1 means the system is optimizing. PRINT DIODE1 PHOTOCELL ?D1PC Returns a voltage that is ...
AVIA 266 Laser Preinstallation Manual 24 PRINT FAULT HISTORY ?FH Returns a list of number codes (see ?F) of all faults that have occurred since the last EXIT SCREEN command, separated by an &, or return "System OK" if no latched faults. The EXIT SCREEN command or the EXIT button on the ...
AVIA 266 Laser Preinstallation Manual 26 PRINT SERVICE SWITCH ?SS Returns the position of the service switch. 0 is user mode. 1 is service mode. PRINT SHG DRIVE ?SHGD Returns SHG temperature servo drive setting. PRINT SHG HEATER ?SHGH Returns the status of the SHG heater: 0 if the SHG heater is OFF ...
AVIA 266 Laser Preinstallation Manual 28 FOLLOWING QUERIES ARE FOR PULSE DELETE AND THERMEQ FUNCTIONS: PRINT PULSE DELETE ?PD Returns the PULSE CONTROL mode of operation. 1 = Pulse Delete On 2 = ThermEQ On 3 = PulseEQ On 4 = PulseTrack On PRINT PULSE DELETE AUTO CALCULATE ?PDAC Returns status of manual ...