Search Results

1 - 12 of 54 Products for 'chiller' Page 1 of 5 |

chiller

DIAMOND J-3 Series OEM Lasers Preinstallation Manual, Rev. AB

DIAMOND J-3 Series OEM Lasers Preinstallation Manual, Rev. AB

…come after the laser system.
Chiller Electrical
Supply
A large industrial chiller normally requires a 230 or 480 VAC,
3-phase electrical supply with its own circuit breaker or fuse
protection and an electrical disconnect. Refer to the chiller
manufacturer's installation…

Paladin Advanced Preinstallation.book

Paladin Advanced Preinstallation.book

…from the chiller. Figure 3-16 shows the connections on the back of
the laser head and chiller. Activate the chiller query with the service
command "CH=1" (see Table 6-3 on page 6-5)
Active Chiller Control The Paladin chiller is preset for "active chiller". "Active chiller"

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

Preinstallation Manual Paladin Advanced Mode Locked UV Laser System

Description and Specifications
2 - 13
Figure 2-4. Termotek Chiller P307-16273 (for 16W-35W Systems) (Continued)
440

00 LMT Pre.book

00 LMT Pre.book


Communications
Input
Assist Gas
Input
Exhaust Sensor
Input
Outlet to Chiller
Remote Interlock
Remote Fan
Regulator Vent
Inlet from Chiller
Control Air Input
Laser Purge Gas
Input
Relay
Pin 1: N.O. Relay Contact
Pin…

00 E-1000 PreInst.book

00 E-1000 PreInst.book

…come after the laser system.
Chiller Electrical
Supply
A large industrial chiller normally requires a 230 or 480 VAC,
3-phase electrical supply with its own circuit breaker or fuse protection and an electrical disconnect. Refer to the chiller manufacturer's
installation…

00 E-400 E-1000 Series Preinstall.book

00 E-400 E-1000 Series Preinstall.book

…come after the laser system.
Chiller Electrical
Supply
A large industrial chiller normally requires a 230 or 480 VAC,
3-phase electrical supply with its own circuit breaker or fuse protection and an electrical disconnect. Refer to the chiller manufacturer's
installation…

00 Legend Elite Preinstallation.book

00 Legend Elite Preinstallation.book

…Damage may occur for unauthorized changes.
Chiller Fluid
Requirements
Evolution Chiller
The Evolution chiller is a closed loop system that requires premixed
Optishield only.
Vitara Chiller
The Vitara chiller is a closed loop system and requires distilled water…

Verdi preinstall.book

Verdi preinstall.book

…fault protection.
4. Proceed to the paragraph titled, "Installing the Chiller".
Installing the
Chiller
Install and setup the chiller in accordance with the user's manual
furnished with the chiller
Final Installation
and Initial
Turn-On
Procedures

Preinstallation Manual Astrella Ultrafast Amplifier Laser System

Preinstallation Manual Astrella Ultrafast Amplifier Laser System

…3-4
Utility Requirements.................................................................................................. 3-4
Chiller Fluid Requirements........................................................................................ 3-5
Facility Water Requirement…

Quick Setup.fm

Quick Setup.fm


1. Hook the laser head to the chiller using the provided hardware, see Figures 1 - 3.
Note, for increased visibility the umbilical has been removed from the laser head in Figure 3.
2. Fill the chiller reservoir with distilled water, start the chiller (see Figure 4), and inspect all…

Avia preinstall.book

Avia preinstall.book

…fault protection.
Installing the
Water Chiller
If the water chiller to be used is provided by Coherent (water chiller
available separately) it will have a separate operation manual with
the installation instructions. The chiller will be shipped with plastic
tubing and…

00 E-250 Pre.book

00 E-250 Pre.book

…minimize the pressure drop from the chiller to the laser
system. Do not exceed the maximum hose length specified by the
chiller manufacturer.
A suitable water filter should be connected as shown in Figure 3-1
on the input water line from the chiller.
Shut-off valves on the…

Powered by Site Search powered by SLI Systems

Please Read Before Continuing

Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.


I have read the terms and conditions