Search Results

1 - 12 of 38 Products for 'external trigger' Page 1 of 4 |

external trigger

LAMBDA SX Excimer Laser Series | Coherent

LAMBDA SX Excimer Laser Series | Coherent

…control Motorized optics mounts (optional) Remote beam adjustment via hand-held control panel Solid-State Switch Maintenance-free operation Purged, External Resonator Design Highest beam stability and optics lifetime Corona Preionization Stable, homogeneous output Metal Ceramic Tube Extended tube…

LabMax-Pro SSIM

LabMax-Pro SSIM

…interfacing, LabMax-Pro SSIM also includes an analog output with user-selectable voltages of 0 to 1V, 2V, or 4V. Triggering can be achieved with an external trigger input or an internal trigger that is user adjustable. The meter is configured as a module for direct PC control and is compatible with…

LaserCam-HR II

LaserCam-HR II

…Adjustable Trigger Delay An adjustable Trigger Delay allows for a delay to be added (µseconds) to the default trigger delay of the LaserCam-HR II camera. This will assist in beam capture when the laser is fired after an external trigger signal that is shorter than the default camera trigger delay.…

Pulse Switch for Mira 900

Pulse Switch for Mira 900

…efficiencies up to 40%
* May be purged for tuning above 920 nm
* Control box (supplied) includes:
* Internal frequency divider (1:2 to 260,000)
* External trigger input (TTL)
* Digital and analog phase adjust of RF pulse (360°)
* Electronic delay
* Synchronization and RF pulse monitor outputs
* RF…

VYPER Series Lasers | Coherent

VYPER Series Lasers | Coherent

…control Motorized optics mounts (optional) Remote beam adjustment via hand-held control panel Solid-State Switch Maintenance-free operation Purged, External Resonator Design Highest beam stability and optics lifetime Corona Preionization Stable, homogeneous output Metal Ceramic Tube Extended tube…

LaserCam HR-InGaAs

LaserCam HR-InGaAs

…Density Adjustable Trigger Delay An adjustable Trigger Delay feature has been added to BeamView-USB 4.4 allowing for a delay to be added (µseconds) to the default trigger delay of the LaserCam-HR camera. This will assist in beam capture when the laser is fired after an external trigger signal that…

EnergyMax-USB Sensors

EnergyMax-USB Sensors

…measurements of every pulse). Additionally, stacking (of up to four) EnergyMax sensors enables all connected units to share both internal and external triggers for synchronized operation, such applications such as pulse-to-pulse ‘A/B’ ratiometry. Support & Download Center Drawing Packages Click…

EnergyMax-RS Sensors

EnergyMax-RS Sensors

…internal and external triggers for synchronized operation, for applications such as pulse-to-pulse “A/B” ratiometry. EnergyMax-RS Sensor Model Accessory EnergyMax-RS must be powered with a 5V DC input. This power must be supplied through an external power supply plugged into the external power input…

EnergyMax-USB/RS User Manual

EnergyMax-USB/RS User Manual

…section:
· Understanding the external trigger circuit (this page)
· Extending cable length (p. 5-2)
Understanding
the External
Trigger Circuit
To prevent ground loop noise from interfering with accurate
measurement, the external trigger input is optically isolated…

LabMax-Pro SSIM User Manual

LabMax-Pro SSIM User Manual

…accurate
measurement, the external SMB trigger input is optically isolated
from the LabMax-Pro internal ground by an optoisolator. The
following figure shows a simplified schematic of the external trigger
input circuitry.
Figure 3-3. External Trigger Input Circuitry

Avia preinstall.book

Avia preinstall.book


?FHGT
Returns FHG measured temperature in °C.
PRINT TRIGGER MODE
?TM
Returns the status of the trigger mode.
0 = internal trigger mode.
1 = external trigger mode.
2 = front panel trigger mode.
PRINT UV ENERGY
?UE
Returns the calibrated output…

2016-Ultrafast-Laser-Systems-Catalog.pdf

2016-Ultrafast-Laser-Systems-Catalog.pdf

…(for non-adjacent pulses)
Repetition-Rate 9 MHz to 200 Hz (internal trigger) for femtosecond configuration
4 MHz to 200 Hz (internal trigger) for picosecond configuration
down to single-shot (external trigger)
Polarization Horizontal
1 At 800 nm.
2 Power change in any…

Powered by Site Search powered by SLI Systems

Please Read Before Continuing

Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.


I have read the terms and conditions