…broad tunability for dedicated use in microscopy and other life
sciences applications have traditionally
been very reliable. These can deliver
years of continuous operation with no
need to ever open the laser. On the other
hand, lasers producing very short pulses
…several airtight thermo-retractable cable gland connections in order to link: i/the MRU unit and power supply to
a wall power socket; ii/the power supply to the computer piloting the MPM setup by a serial port; and iii/the laser
head to a spectrometer by a USB port. Finally, the…
BNC signal lines (trigger and gate) in order to control the
laser system. This subject is highly dependent on your
application. Refer to the chapter "Operating the Laser" in
the Operator's Manual or contact your Coherent representative. Refer to…
…producing a fully bonded layer with very
Giantree Laser Technology (Shanghai,
China), one of the leaders in laser cladding applications in China, has extensive firsthand experience with laser cladding, thermal spray coating, machining/
grinding, and materials/alloys…
…km/year in conjunction with highly viscous media having abrasive or adhesive properties.
To date, the clads produced using the
R:LM² process from entirely ferrous
alloys have proven effective in these
KSD is also developing applications for laser additive…
…both CW and pulsed lasers,
whereas knife-edge profilers can only be used with CW lasers,
unless special techniques are used in addition which are
complicated and expensive.
Image Capture Rates
The speed of beam image capture will depend on the computer
being used, type…
…topic in this guide and in
the Coherent StingRay Operator's Manual (1223124) for
the optical safety information.
Note: In this configuration the laser is NOT CDRH
compliant for end-use applications. This laser will start
emission when power is applied to the laser. Care…
…right colored capsule goes in the correct bottle in drug packaging lines.
Another laser application is alignment. In computer assembly, a laser system can help an operator determine if a
computer chip is perfectly positioned on a circuit board.
Lasiris lasers can be useful for contour…
…Note that in this configuration the laser is CDRH compliant for end-use applications. This laser will
not start emission until the interlock and key switch are enabled and power applied to the controller.
Once these conditions are met, the laser will begin emitting in 5 seconds (safety…
found widespread use in a diverse range
of industrial processing applications?
The answer is that CO laser technology
could not be made practical, reliable
and cost effective enough for commercial use. In particular, early CO lasers
required cooling in…
…the Chameleon and OPO outputs to
compensate for losses in complex microscope systems
and to enable deep multimodal imaging.The industry's
smallest footprint of Chameleon Compact OPO makes
it simple to add this laser to existing multiphoton
set-ups and upgrade MPE facilities…
…technologies in order to manufacture smaller, more powerful and more reliable devices at
lower cost. New laser applications and new laser technologies are a key element in delivering higher
resolution and higher precision at lower manufacturing cost.
We support three major markets in…
Please Read Before Continuing
Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.