Search
Superior Reliability & Performance

  • Lasers and Laser-based Systems
  • Laser Measurement and Control
  • Precision Optics
  • Related Accessories
1 - 10 of 34 Search Results for libra manual

1pdf document  Libra Preinstallation Manual Best match in this PDF  |  All matches in this PDF
Pre-Installation Manual Libra Ultrafast Amplifier Laser System 5100 Patrick Henry Drive Santa Clara, CA 95054 USA Libra Pre-Installation Manual ii This document is copyrighted with all rights reserved. Under copyright laws, this document may not be copied in whole or in part, or reproduced in any other…
Related Searches: eye damage | sdg | evolution manual

2COHR_RLS2009_catalog.pdf  (PAGE 64 OF 76)
…, Libra and Hidra Amplifiers
62
HGS-D HGS-T HGS-F
Conversion Efficiency (%, from 800 pump, fsec) 35 15 1
Power Stability (%, rms) 1.5 2.5 3.5
The HGS accessory provides extremely convenient
second-, third- or fourth-harmonic output for kHz
Legend Elite and Libra Ti…
Related Searches: third harmonic generation

3Libra PreInstallation.book  (PAGE 24 OF 35)
Libra Pre-Installation Manual
2 - 6
Synchronization
and Delay
Generator (SDG)
The SDG controls the precise timing of the RA Pockels cells. It
contains a high-speed power supply for the Pockels cells as well as
a bandwidth detector (BWD) circuit, which serves as an interlock…
Related Searches: sdg

4Libra PreInstallation.book  (PAGE 26 OF 35)
Libra Pre-Installation Manual
3 - 2
Utility and
Environmental
Requirements
The following tables provide pertinent information concerning the
installation of the Libra.
.
Table 3-1. Libra Utility Requirements
SYSTEM COMPONENT 110 ± 10 V 50/60 HZ (AMPS) 220…

5Libra Preinstallation Manual
Loading... Libra Preinstallation Manual Libra Preinstallation Manual Click here if you are not re-directed.

6Libra PreInstallation.book  (PAGE 12 OF 35)
Libra Pre-Installation Manual
1 - 6
Operating
Controls
The laser controls are positioned so that the operator is not exposed
to laser emission while manipulating the controls [CFR
1040.10(f)(7)/EN 60825-1/IEC 60825-1, clause 4.8].
Manual Reset
Mechanism
Following…

7Libra PreInstallation.book  (PAGE 5 OF 35)
Libra
systems, and is a supplement to the Coherent Libra Operator's
Manual.
Read this Pre-Installation Manual carefully before operating
the system for the first time.
Use of controls or adjustments or performance of procedures
other than those specified in this Manual

8Libra PreInstallation.book  (PAGE 20 OF 35)
Libra Pre-Installation Manual
2 - 2
Libra Optical
Bench Assembly
The Libra optical bench assembly comprises four modules (see
Figure 2-2 on page 2-3):
· Vitesse seed laser
· Evolution pump laser
· Regenerative amplifier (RA)
· Stretcher/Compressor

Related Searches: evolution manual

9Libra PreInstallation.book  (PAGE 32 OF 35)
Libra Pre-Installation Manual
3 - 8
External
Interlock
The use of system interlocks is important to assure safe operation of
the laser system.
An external interlock connector is provided on the SDG Elite rear
panel. In the event of an interlock fault during normal operation…
Related Searches: sdg | sdg elite

10Libra PreInstallation.book  (PAGE 4 OF 35)
Libra Pre-Installation Manual
iv
LIST OF FIGURES
1-1. Libra Safety Labels.......................................................................................................... 1-7
2-1. Libra Optical Bench Assembly..............................................................…
Related Searches: sdg elite


Page 1 2 3 4 of 4 | Next


Site Search by  Site Search powered by SLI Systems
.