1 - 9 of 9 Search Results for rf warning lights
|
|
|
2.
RF Warning Faults
|
|
RF Warning Faults Click here for Coherent Technical Support contact information. Superior Service Solutions 40+ years of experience Supporting critical environments Highest level of post-sale customer care Long-term customer relationships RF warning signals should be measured while the laser is receiving ...
Related Searches: integrators
|
|
|
|
|
3.
RF Warning Lights On
|
|
RF Warning Lights On Click here for Coherent Technical Support contact information. Superior Service Solutions 40+ years of experience Supporting critical environments Highest level of post-sale customer care Long-term customer relationships Related symptoms; VSWR light on, Duty Cycle light on, Forward ...
Related Searches: rf module
|
|
|
|
|
4.
No Laser Output Beam
|
|
|
Verify that the power module is on and ready light is on. Click here for illustration If fault lights (red) are lit, clear faults. Click here for illustration Open shutter and verify that the shutter open indicator is illuminatedNOTE: The next step will attempt to operate the laser. A powe"> ...
|
|
|
|
|
5.
CO 2 Basic
|
|
... critical environments Highest level of post-sale customer care Long-term customer relationships Please select an issue: Related Links . Head Cover Light On Head Thermal Light On Laser System Doesn't Turn On Laser System Shuts Down at Hight Power Setting Low Laser Power No Aiming Beam No Laser Output ...
Related Searches: co2
|
|
|
|
|
6.
CO 2 Performance Package
|
|
|
... environments Highest level of post-sale customer care Long-term customer relationships Please select an issue: Related Links . Head Cover Light On Head Thermal Light On Laser System Doesn't Turn On Laser System Shuts Down at Hight Power Setting Low Laser Power No Aiming Beam No Laser Output Beam ...
|
|
|
|
|
7.
Low Laser Power
|
|
... gas and purge gas filter, see the chapter titled "Utility Requirements and System Installation" in the Operator's Manual for details. If RF warning lights are on troubleshoot as necessary. Replace power module, laser head, and/or RF cable if necessary depending on warning lights and troubleshooting ...
Related Searches: diamond k-250 | k-250 | power meter | laser power meter
|
|
|
|
9.
Diamond_Integrators_Guide_RevAA
(PAGE 47 OF 56)
|
|
|
... shuts the laser down, so it is not a good idea to put work chamber door switches on it. These should be interlocked to the laser shutter (or to RF enable for systems with manual shutters) instead. When the DC power supply is on, Pins 1 and 2 are switched together by a relay in the DDI. This can be used ...
|
|
Coherent Contact Information