1 - 10 of 406 Search Results for soldering
|
|
|
1.
Coherent Inc. Welding Brazing and Soldering
|
|
|
…welding techniques. The total heat affected zone is therefore much lower. Laser soldering is increasing in popularity as the soldering of heavily populated PCB's and PWB's becomes increasingly difficult. Lasers can solder smaller joints than are possible using conventional manual techniques. Both CO 2…
|
|
|
|
3.
Soldering TelecomRev2
|
Best match in this PDF
|
All matches in this PDF
|
|
…and electrical conductivity. Gold-compatible solders are therefore required in a very wide range of photonics devices. There are, however, problems associated with the use of gold as a solderable coating. Gold enrichment (or dilution of tin) in the solder joint due to the rapid dissolution of gold plating…
|
|
|
|
|
5.
Coherent Inc. Diode Laser Soldering
|
|
…carrier was soldered onto a purpose-built test board. The pitch of the pins was one-tenth of an inch, and the through-holes 1.7 mm in diameter. Solder pre-forms were hand-placed over the pins on the exit side of the holes. Both lead-tin and lead-free solders were investigated. After soldering, the joints…
Related Searches: diode laser soldering | fap system | glass cutting
|
|
|
|
|
6.
Coherent Inc. Applications Finder
|
|
|
…-Material Removal Cladding Cutting and Scribing Drilling Heat Treating Marking and Engraving Sub-Surface Modification Surface Modification Welding and Soldering View All Application Notes Diamond Drilling with DPSS Lasers Diamond thin films are finding increasing use in semiconductor devices because they enable…
|
|
|
|
|
10.
Micro-welding
(PAGE 1 OF 2)
|
|
…soldering
time was fixed at 0.8 sec.: Therefore, average
power and solder composition were the primary variables studied. Average power was
changed in increments of 2 watts over the
range at which solder joints were produced.
At each setting, a total of 13 pins were soldered.…
Related Searches: diode laser soldering
|
|
