1 - 10 of 45 Search Results for transmission welding
|
|
|
2.
Laser welding
(PAGE 1 OF 1)
|
|
…welding of plastics. The main principle now
used to laser-weld plastics is known as "transmission welding."
Transmission welding has demonstrated that precise, controllable
heating and melting of low melting point thermoplastics can be
produced at the interface between a transmissive…
Related Searches: plastic welding
|
|
|
|
|
4.
Micro-welding
(PAGE 1 OF 2)
|
|
…welding of
plastics. The main principle now used to
laser-weld plastics is known as "transmission welding." Transmission welding has
demonstrated that precise, controllable
heating and melting of low melting point
thermoplastics can be produced at the interface between a transmissive…
Related Searches: plastic welding
|
|
|
|
5.
Laser weldingRev2
|
Best match in this PDF
|
All matches in this PDF
|
|
…laser welding of plastics. The main principle now used to laser-weld plastics is known as "transmission welding." Transmission welding has demonstrated that precise, controllable heating and melting of low melting point thermoplastics can be produced at the interface between a transmissive and absorptive…
|
|
|
|
|
8.
Micro-welding
(PAGE 1 OF 2)
|
|
…
of small diameter, single-mode telecommunication fibers to substrates, where sub-micron
accuracy is required to maximize optical signal transmission. Joint stability is necessary
to ensure the long-term performance of devices, but reducing manufacturing cost and
complexity are also…
Related Searches: welding
|
|
|
|
|
9.
EOOct05
|
Best match in this PDF
|
All matches in this PDF
|
…programmed to follow a weld seam. Not only is this system 10 times faster than traditional spot welding, but it also gives stronger joints, which leads to better structural rigidity and, perhaps most important, better crash protection. Laser-welded joints absorb more energy than spot welds and do not distort…
Related Searches: honing
|
|
|
|
|
10.
LasersBestPresc_0402Rev2.pdf
(PAGE 8 OF 8)
|
|
…feasibility of the
transmission welding technique and joint configuration for this material, a standard nearinfrared, low-power industrial laser system
also emitting in the 975-nm wavelength was
used to develop laser-processing parameters.
On production of the laser weld, it was noted
…
|
|
