Ask a Question
Coherent
Search Results
Refine

Result Type

1 - 12 of 48 Products for 'verdi v5 manual' Page 1 of 4 |

verdi v5 manual

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 11

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 10 Figure 1-8. Power Supply Dimensions

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 2 1. Riser/heat sink installation hardware 2. Operator's manual 3. AC power cord 4. Power supply key 5. Installation kit case 6. Interlock-disassembled 7. Fuses and instructions 8. FAP-I installation hardware, including shorting clips, end caps, etc. 9.…

Verdi preinstall.book

Verdi preinstall.book

Preinstallation Manual VerdiTM V-2/V-5/V-6 Diode-Pumped Lasers 5100 Patrick Henry Drive Santa Clara, CA 95054

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual vi

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual iv Preface This manual contains user information for the VerdiTM V-2/V-5/V-6 Diode-Pumped Lasers. Read the Operator's Manual carefully before operating the laser for the first time. Special attention should be given to the material in Section One, Laser…

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 6 Each customer must inspect the power cord and install the proper connector if necessary. The connector should be installed in a properly grounded outlet with a maximum of 10 Ampere service @ 110 V and 11 Ampere service @ 220 V for proper overcurrent…

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 10 Figure 1-8. Power Supply Dimensions

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 5 6. Proceed to the paragraph titled, "Installing the Power Supply". The riser/heat sink clamps and chiller connection will be installed during the final installation procedures. Installing the Power Supply 1. Move the power supply to an…

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual vi

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual 8 5. The interlock circuit in Verdi operates from a +/-12 VDC circuit. Its current is limited to around 1 mA. For these ratings, a "dry-circuit" type switch will give the most reliable operation. Figure 1-6. Interconnect Diagram Table 1-1. Utility…

Verdi preinstall.book

Verdi preinstall.book

Verdi V-2/V-5/V-6 Laser Preinstallation Manual ii This document is copyrighted with all rights reserved. Under the copyright laws, this document may not be copied in whole or in part or reproduced in any other media without the express written permission of Coherent, Inc. Permitted copies must carry…

Powered by Site Search powered by SLI Systems

Call 1-800-227-8840


Outside the U.S. 1-408-764-4983

Coherent has locations across the globe that are available to provide support for any product, service or inquiry.

Visit our Contact Page to connect with any of our global sites.


Corporate Headquarters
Coherent Inc.
5100 Patrick Henry Drive
Santa Clara, CA 95054 USA

email: tech.sales@coherent.com

Send Us a Message

Please Read Before Continuing

Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.


I have read the terms and conditions