1 - 10 of 24 Search Results for wavemate
|
|
|
2.
Book.book
(PAGE 12 OF 36)
|
|
…
WaveMate's unique detector head design incorporates a
temperature-stabilized dual wavelength response sensor
element with built in variable attenuator, AutoBlockTM
background references shutter, and a background
limiting alignment insensitive beam input port.
WaveMate is calibrated…
|
|
|
|
|
3.
Book.book
(PAGE 25 OF 36)
|
|
WaveMate User Manual
16
Optional
Analog Output
Operation
The Analog Out Interface option for the WaveMate
wavelength meter provides an output voltage between
4.5 and 10.0V that is proportional to the measured wavelength. The voltage value at the output directly corresponds…
|
|
|
|
|
4.
Book.book
(PAGE 13 OF 36)
|
|
WaveMate User Manual
4
For non-pulsed measurement applications, an economical CW-only version of the WaveMate is available.
WaveMate comes standard with an RS-232 serial port,
cable, and interface software. Standard ΒΌ-20 and 6 mm
tapped holes are provided for convenient mounting…
|
|
|
|
|
5.
Book.book
(PAGE 7 OF 36)
|
|
WaveMate User Manual
vi
Appendix A: Specifications..................................................................25
LIST OF TABLES
1. RS-232 Software Commands.....................................................................17
2. Coherent Service Centers..............…
|
|
|
|
|
6.
Book.book
(PAGE 17 OF 36)
|
|
WaveMate User Manual
8
Setup Connect the sensor head to the socket on the back panel
of the console (Figure 4). Check the AC setting switch
on the back of the console.
AC switch must be set to the correct voltage for the
unit to operate properly. Unit may be damaged if…
|
|
|
|
|
7.
Book.book
(PAGE 3 OF 36)
|
|
WaveMate User Manual
ii
This document is copyrighted with all rights reserved. Under
the copyright laws, this document may not be copied in whole
or in part or reproduced in any other media without the
express written permission of Coherent, Inc. Permitted copies
must carry…
|
|
|
|
|
8.
Book.book
(PAGE 23 OF 36)
|
|
WaveMate User Manual
14
When in the manual mode, offset correction should
be done every 15 minutes for accurate measurements.
Shutter Sets internal shutter to ON or OFF. When on, internal
shutter in sensor head is closed each time offset correction is made. When off, internal…
|
|
|
|
|
9.
Book.book
(PAGE 2 OF 36)
|
|
User Manual
WaveMate
Wavelength Meter
27650 SW 95th Ave.
Wilsonville, OR 97070
|
|
|
|
|
10.
Book.book
(PAGE 5 OF 36)
|
|
WaveMate User Manual
iv
|
|
